Template:Toggle dive maps/doc

This template is used to display dual maps at the same place in on a page. A static map of dive regions or sites and a toggling interactive map showing points of interest Use of this template is as follows:

{{Toggle dive maps
| regionmap=The name of the region map.file type (Required)
| regionmaptext=Text to display under the map image. (Optional. Defaults to "Map of the dive sites at {{SUBPAGENAME}}" if not passed)
| regionmapsize=The size of the map in px. (Optional> Defaults to 350px if not passed)
| regionInteractiveMap=map1 (Required. No point in using the template if this is not given. Must be different for each static/interactive map toggle set on the page)

}}

The regionInteractiveMap parameter will activate a dynamic map behind the static map, and provide a link to switch between the maps. If there are mapshapes to display in the dynamic map, they will need to have the "group=map1" parameter added.

Example: {{mapshape|type=geoshape|fill=#dcb8b8|wikidata=Q14925052|group=map1}}

Some things to note:

• The static and dynamic maps will have identical dimensions so the layout of the article is not affected.
• The center and the zoom of the map will be autoset according to the POI shown in the map.
• To set a dynamic map for a second static map on the same page, it's necessary to specify a different value in the regionInteractiveMap parameter (e.g. map2) and match it to group parameter in the {{mapshape}}.

Optional parameters

To center the map at a different point or to apply a different zoom level, use the following optional parameters.

| regionmapLat=Center latitude (decimal degrees)
| regionmapLong=Center longitude (decimal degrees)
| regionmapZoom=Map zoom level (Defaults to auto)

Full template:

{{Toggle dive maps
| regionmap=
| regionmaptext=
| regionmapsize=
| regionInteractiveMap=map1 
| regionmapLat=
| regionmapLong=
| regionmapZoom=
}}